Yamaha FJR1300 Oil Capacity, Oil Grade, Viscosity, Oil Type

In Yamaha FJR1300 the engine oil capacity is 4.0 quarts when changing the oil. You need 4.2 quarts if you change the oil filter too.

The Yamaha FJR1300 is a remarkable sport-touring motorcycle known for its power, handling, and long-distance comfort.

With the proper oil and regular oil changes, an FJR1300 can reliably rack up high miles.

Here’s a look at Yamaha FJR1300 oil capacity, recommended oil types, and key maintenance tasks.

Yamaha FJR1300 Oil Capacity for Different Model Years

The engine oil capacity is approximately 4.0 quarts on all FJR1300 models from 2004 through 2015.

When changing the oil filter, add 4.2 quarts to account for residual oil in the filter.

On 2004-2005 FJR1300s, put in 4.0 quarts after draining the old oil, or 4.2 quarts if replacing the oil filter.

2007, 2008, and newer FJR1300s also take 4.0 quarts of new oil without changing the oil filter, or 4.2 quarts if installing a new oil filter.

Yamaha FJR1300 Oil Change Interval

Yamaha recommends changing the engine oil every 4,000 miles or 6 months. More frequent changes may be needed with extensive idling or hot weather riding.

This helps remove contaminants and replenish additives that break down over time.

Use the manufacturer-recommended oil types and weights to ensure the FJR1300 performs optimally.

Consistent oil changes are vital for achieving high mileage on this outstanding motorcycle.

Yamaha FJR1300 Oil Grade

Yamaha calls for synthetic or conventional motor oil grade 10W-40 or 20W-50 for the FJR1300 engine across all model years. Specific recommendations include:

  • SAE 10W-40
  • SAE 15W-50
  • SAE 20W-50

For 2015 and newer FJR1300s, Yamaha specifies mineral or synthetic oil that meets JASO MA viscosity standards. Look for this certification on oil bottles.

Using the manufacturer-recommended viscosity helps ensure proper oil flow and protection across operating temperatures.

Yamaha FJR1300 SAE 20W-50 vs SAE 10W-40 Viscosity

Specification20W-5010W-40
Viscosity at 100°C18.5 cSt14.5 cSt
Viscosity at 40°C172 cSt96 cSt
Viscosity Index110157
Pour Point-27°C-39°C
Flash Point244°C230°C
TBN6.5 mg KOH/g7.4 mg KOH/g
Sulfated Ash0.8%0.9%
  • SAE 20W-50 is thicker at high and low temperatures with a viscosity index of 110 vs 157 for SAE 10W-40
  • SAE 10W-40 flows better at low temperatures with a lower pour point
  • SAE 10W-40 has slightly higher TBN and sulfated ash for potentially better corrosion protection
  • SAE 20W-50 may provide better protection at extremely high temps for high-performance engines
  • SAE 10W-40 meets requirements for a wider range of vehicles and conditions

To keep your FJR1300 running optimally, Yamaha advises changing engine oil every 4,000 miles or 6 months, whichever comes first. Riding in dusty conditions or running the engine at high rpm requires more frequent oil service.

Yamaha FJR1300 Oil Filter and Drain Plug Locations

The oil filter on FJR1300 models is conveniently placed for access on the lower left side of the engine.

Use a filter wrench to remove and install it.

The oil drain plug is on the bottom of the crankcase, behind the oil filter.

The drain plug and filter torque specs are listed in the owner’s manual.

Checking Yamaha FJR1300 Oil Level

Check the oil level routinely, especially before longer rides.

Refer to the owner’s manual for proper checking procedures.

Insert the dipstick without screwing it in and withdraw to check the level.

Add oil as needed through the fill hole on top of the engine behind the seat.

Use caution as this area can get hot. Do not overfill. Check valve adjustments too when checking the oil level and adjust the clearances if necessary.

Yamaha FJR1300 Oil Capacity and Oil Specifications

FJR1300 Final Drive Oil Specifications

The final drive on the FJR1300 requires Hypoid gear oil, not motor oil like the engine. The final drive oil capacity is 0.5 quarts or 500 ml.

Recommended oil grades are SAE 80 or 90 Hypoid Gear Oil. The oil change interval is every 12,000 km (7,500 miles) according to one manual.

Specific Hypoid gear oils mentioned in the manuals include Yamalube Hypoid Gear Oil of grade SAE 80 and Mobilube 1 SHC 75W-90 (synthetic).

To check the final drive oil level, place the motorcycle on level ground and the side stand. Unscrew the level check bolt and make sure the oil flows out.

To drain the old oil, remove the drain bolt at the bottom of the final drive housing. Refill with new oil to the proper level through the check bolt hole.

Proper oil level is when the oil just starts to flow out of the check bolt hole on level ground.

The tightening torque for drain and check bolts is 22 Nm.

Be sure to thoroughly clean the drain bolt and sealing surfaces when reinstalling. Apply a thin coat of lithium soap base grease to bolt threads and sealing surfaces.

FJR1300 Fork Oil Capacity

Each fork leg on the 2007 Yamaha FJR1300 holds 700ml or 23.67 oz of Fork Oil.

The recommended fork oil grade is SAE 5W or SAE 10W.

Specific fork oils mentioned include Yamalube Suspension Oil SAE 5W and SAE 10W.

To check the oil level, remove the damping rod bolt and insert the oil level gauge. The proper level is 105 mm above the top of the outer tube with the fork fully compressed.

To drain oil, remove the damping rod bolt and drain screw at the bottom of the fork.

Reinstall the drain screw with a new sealing washer after draining the old oil.

Fill each fork to the proper level with new oil through the damping rod bolt hole.

Bleed forks by pumping the damping rod up and down 10-15 times to remove air bubbles after filling.

The oil change interval is not specified but likely every 12,000-15,000 miles for average riding. More often for aggressive riding.

Proper fork oil level and viscosity are important for suspension feel and performance.

Conclusion

Make sure the FJR1300 oil capacity is

With routine oil changes and oil filter service, your FJR’s engine will provide miles of riding enjoyment.

Check your owner’s manual for full specifications.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top